- Battery Eliminator
- Clutch, Throttle, Speedo Cables
- Oil Filter
- Tail Light
- Exhaust Wrap
- Wires and Adapters for wiring.
The only thing left is the Baffles (if needed) and Grips. It's getting exciting knowing here next Sunday I should be putting some touches on it.
Another thing is I did post earlier this week about sewing the seat fabric together. Well after 2 skateboards and some fancy hand work. Seat is done. Turned out as expected. Notice I used a skateboard for the template, cut my old seat foam up and fitted it over the board. Wrapped the fabric over it, used a heat gun to bend over the corners with the least amount of over lapping possible. Screwed that fabric down after doing a presunk hole was drilled. Cut out the second skateboard the same size and bolted the two boards together. This way the fabric will stay together on the board a little better and also it will have the skateboard appeal because it is showing.
No comments:
Post a Comment